Certifications 2

ManualsBrandsGAMMA SCOUT ManualsRadiation Measurement® Radiation Detector with USB-Port

DYNAMIS Batterien GmbH Brühlstr. 15 D-78465 Dettingen / Konstanz Tel. +49 7533 93669-0

info@dynamis-batterien.de www.dynamis-batterien.de Fax +49 7533 93669-91

Version 01.01.2021

Page 1 of 5

Material Safety Data Sheet

Lithium Ion Line Cells and Batteries (LO Series)

Section I – Information of Manufacturer

Manufacturer’s Name: DYNAMIS Batterien GmbH

Address: Brühlstr. 15 D-78465 Dettingen / Konstanz

Tel. +49 7533 93669-0

Section II – Composition/Materials

Description: CAS# wt-%

1. Lithium Cobalt Oxide 12190-79-3 20-40

2. Aluminium (various forms) 7429-90-5 5-15

3. Carbon (various forms) 7740-44-0 10-30

4. Copper 7440-50-8 5-15

5. Lithium Salts 21324-40-3 1-5

6. Nickel 7440-02-0 0.5-5

7. Organic Carbonate 102-09-0 10-25

8. Polymer 9002-88-4 3-10

Section III – Physical / Chemical Characteristics

Boiling Point: N/A

Vapour Pressure (mm Hg): N/A

Vapour Density (AIR=1): N/A

Solubility in Water: N/A

Appearance and Odour: Sealed round cell metal can, with pos./neg. terminals and over-

pressure safety vent, PTC

Specific Gravity (H2O=1): N/A

Melting Point: N/A

Evaporation Rate (Butyl Acetate): N/A

Use properties: Secondary (rechargeable) power supply, nominal voltage 3.7V

Temperature: Storage, continuous max. +35 °C

Storage, occasional -20 °C to +50 °C

Discharge, cont. max. +60 °C

Discharge, occ. -20 °C to +60 °C

Charge, cont./occ. 0 °C to +45 °C

Energy content, specific: 135 Wh/kg

Summary of content (5 pages)

PAGE 1
Material Safety Data Sheet Lithium Ion Line Cells and Batteries (LO Series) Section I – Information of Manufacturer Manufacturer’s Name: DYNAMIS Batterien GmbH Address: Brühlstr. 15 D-78465 Dettingen / Konstanz Tel. +49 7533 93669-0 Section II – Composition/Materials Description: CAS# wt-% 1. Lithium Cobalt Oxide 2. Aluminium (various forms) 3. Carbon (various forms) 4. Copper 5. Lithium Salts 6. Nickel 7. Organic Carbonate 8.
PAGE 2
Section IV – Hazard Classification All chemicals are sealed into the cell box. Risk of exposure only possible if the integrity of the cell box is mechanically or electrically damaged (by abuse). In these cases contact of Lithium components or electrolyte with skin or eyes shall be avoided. A ruptured or shorted battery box cause thermal or chemical burns upon contact with skin. This may be a reproductive hazard.
PAGE 3
Section V – Reactivity Data Stability: Stable Status Conditions to Avoid: Fire/Heating above specified range (+85 °C), short circuiting tools or solvents, mechanical/electrical abuse. Incompatibility (Materials to Avoid): Acids, Water, Metal corroding/Oxidizing materials. Hazardous Decomposition of By-products: Reaction of water with free electrolyte generates HF. HF is corrosive and irritant, and can be very harmful in contact with skin/eyes or when inhalated. Immediate medical attention necessary.
PAGE 4
Section IX – Accidental Release or Spillage Steps to Be Taken in Case Material is Released or Spilled: If the battery material is released, remove personnel from area until fumes dissipate. Provide maximum ventilation to clear out hazardous gases. Wipe it up with a cloth, and dispose of it in a plastic bag and put into a steel can. The preferred response is to leave the area and allow the battery to cool and vapors to dissipate while maximum ventilation is provided.
PAGE 5
Section XII – Ecological Information When properly used or disposed of the battery does not present an environmental hazard. When disposed avoid water, rain and snowy conditions for long-term storage. Section XIII – Disposal Method General: Dispose of batteries according to government regulations. If batteries are still fully charged or only partially discharged, they can be considered a reactive hazardous waste because of significant amount of unconsumed energy remaining in the spent battery.