Operation Manual
Deleting the Data
At the end of the data reading process, by selecting “delete” from the menu.
If you are not in the reading program, you can use the button (page 14).
R
Data Reading (TOOLBOX Software)
16
For details and troubleshooting, see www.gamma-scout.com
Reading the Data
Requirement: The device software (TOOLBOX) must be installed on your hard drive.
1. Connect your GAMMA-SCOUT
®
with your PC
Connect GAMMA-SCOUT
©
with PC using the USB cable supplied.
2. Download the data
Start the program from your PC using “GAMMA-SCOUT® TOOLBOX”
(Start/All Programs/GAMMA-SCOUT®TOOLBOX). For new devices, manual program start is
no longer necessary.
The data transfer starts automatically (ca. 30 seconds delay).
The following data table must appear (possibly via the menu command “notication area”)
Should the table not appear automatically, please disconnect the cable, wait for around one
minute and retry (plug & play).