User Guide

2
3
controller
getting started
Set up your PlayStation
®
2 computer entertainment system according
to the instructions in its Instruction Manual. Make sure the
MAIN
POWER switch (located on the back of the console) is turned ON .
Press the
RESET button. When the power indicator lights up, press
the
OPEN button and the disc tray will open. Place the ROGUE
TROOPER
™
disc on the disc tray with the label side facing up. Press
the
OPEN button again and the disc tray will close. Attach game
controllers and other peripherals, as appropriate. Follow on-screen
instructions and refer to this manual for information on using
the software.
MEMORY CARD (8MB)(for PlayStation
®
2)
To save game settings and progress, insert a memory card (8MB)(for
PlayStation
®
2) into MEMORY CARD slot 1 before powering on the
system. At least 170KB of free space on the memory card is required
to save game data.
This game supports saving and loading of game data in MEMORY
CARD slot 1 only. You can load saved game data from the same
memory card or from any memory card containing previously saved
ROGUE TROOPER
™
games.
E See page 16 for more information on saving game data.
Connect the DUALSHOCK
®
2 analog controller to controller port 1
before starting play. When the vibration function is
On , the
controller will vibrate in response to game events. You can
reconfigure the controls and toggle the vibration function
On/Off
in Options mode.
E Options Mode, page 8.
E All controls in this manual are the default controls.
E This game can only be played using an analog controller.
open button
on/standby/
reset button
IR receiver
USB connectors
disc cover
controller port 1
controller port 2
memory card slot 1
memory card slot 2
button
button
button
button
directional
buttons
left analog stick
(L3 button
when pushed down)
SELECT button
ANALOG mode button
START button
right analog stick
(R3 button
when pushed down)
L2 button
L1 button
R2 button
R1 button
DUALSHOCK
®
2 ANALOG CONTROLLER CONFIGURATIONS
rt ps2 final.qxd 4/13/06 5:08 PM Page 2