User Guide

3
standing
Movement Left analog stick or directional buttons
Dash* Hold r button while moving
Grapple c button
Attack 1 s button
Attack 2 x button
Guard Break 1* r + s buttons
Guard Break 2* r + x buttons
Pickup Weapon t button
Block Hold d button
Attack Counter* l + r buttons as opponent begins attack
Pin l button while opponent is on ground
Ground Submission* r + c buttons while opponent is on ground
Ground Attack 1 s button while opponent is on ground
Ground Attack 2 x button while opponent is on ground
Ledge Throw 1 s button while holding opponent on ledge
Ledge Throw 2 x button while holding opponent on ledge
• This action requires some amount of Turbo Meter. For info, see Turbo Meter on page 8.
2
getting started
game controls
Set up your PlayStation
®
2 computer
entertainment system according to the
instructions in its Instruction Manual. Make
sure the MAIN POWER switch (located on the
back of the console) is turned ON.
Press the RESET button. When the power
indicator lights up, press the OPEN button
and the disc tray will open. Place the
BACKYARD WRESTLING 2: THERE GOES THE
NEIGHBORHOOD
disc on the disc tray with the
label side facing up. Press the OPEN button
again and the disc tray will close.
Attach game controllers and other
peripherals, as appropriate. Follow on-screen
instructions and refer to this manual
for information on using the software.
MEMORY CARD
(8MB)(for PlayStation
®
2)
To save game settings and progress, insert
a memory card (8MB) (for PlayStation
®
2)
into MEMORY CARD slot 1 before powering on
the console.
• At least 150KB of free space on the memory
card is required to save game data.
• This game supports saving and loading
of game data in MEMORY CARD slot 1 only.
• You can load saved game data from the
same memory card or any memory card
containing previously saved
BACKYARD
WRESTLING 2: THERE GOES THE
NEIGHBORHOOD
games.
DUALSHOCK
®
2 ANALOG CONTROLLER CONFIGURATIONS
Note: illustration may not match all PlayStation 2
console types. For owners of SCPH-70000 series
PlayStation 2 systems, refer to the setup instructions
supplied with your system.
Connect the DUALSHOCK
®
2 analog controller to controller port 1 before starting play.
For 2 Player games, connect a second controller to controller port 2.
When the vibration function is ON, the controller will vibrate in response to game events.
You can turn the vibration function ON/OFF in the Options Mode. See page 12.
byw2 ps2 b-w approved 10/7/04 1:06 PM Page 2