User Guide

3
STRIKE COMMANDER CD
INSTALL AND ADDITIONAL
REFERENCE GUIDE
See p.18 for Contents.
INTRODUCTION
Welcome to Strike Commander on CD. This guide tells you how to install your new game.
If you have any difficulties, see Troubleshooting (pp. 10-13). To avoid compatibility
or
memory problems, please take a moment to make sure that your system meets the
system requirements.
SYSTEM REQUIREMENTS
Computer. This game calls for an Intel486 or 100% compatible system.
Video Card. IBM VGA or compatible video card.
Free RAM. You must have at least 640K of base RAM (memory) to play Strike
Commander. Of that 640K, at least 557K (571,000 bytes) of base memory must be
available at the DOS prompt to run the minimum game configuration. You must also
have at least 2700K (2,765,000 bytes) high memory:
If your CONFIG.SYS contains an EMS driver, you must have 2700K (2,765,000
bytes) of EMS memory available.
If your CONFIG.SYS does not have an EMS driver, you must have 2700K
(2,765,000 bytes) of XMS memory available.
Strike Commander won’t run with less than that. See Memory Requirements (p. 6) for
more information.
Hard Disk. You must have a minimum of 2 megabytes free on your hard disk to install
and play Strike Commander CD.
CD-ROM. MS-DOS CD-ROM extensions 2.1 or higher are required; a CD drive with
350ms or faster seek time is recommended.
ON-LINE HELP
Press 1 for on-line help during installation.
QUICK INSTALL
1. Insert the CD-ROM (label side up) into your CD-ROM drive.
2. Change to your CD-ROM drive.
3. Type
INSTALL.
4. Follow the instructions at each prompt.