User Guide

To install your SOUND CARD DRIVERS;
Make sure that the BOOT DISK that you
created is in the A DRIVE.
1) Type “CD C:\SBPRO” [RETURN].
Note: Not all sound card manufacturers set their
software in the following manner. These direc-
tions are for the CREATIVE LABS SOUND
BLASTER PRO sound card. These instructions
assume that your sound card software has been
installed in a directory called SBPRO.
2) Type “INSTALL” [RETURN].
3) Follow the instructions on the screen until is
asks you “Where do you want to install the
sound drivers. When prompted, tell it to
install the mouse drivers to your A FLOPPY.
After this is complete your sound drivers
will be installed on the BOOT DISK.
Playing
Kingmaker with the BOOT DISK:
After you have completed creating a BOOT
DISK, you are ready to begin playing
King-
maker.
1) Make sure that the BOOT DISK is inserted
in the A DRIVE.
2) Reboot your computer by hitting the RESET
button, or by holding down the CONTROL,
ALT and the DELETE key at the same time.
3) When the system has finished booting up,
type “C:\KING” [RETURN].
4) Type KING and you are ready to begin!
TROUBLE SHOOTING
(PROBLEMS & SOLUTIONS):
PROBLEM: THE NARRATOR SPEAKS ONE
OR TWO WORDS AND THE VOICE STOPS.
SOLUTION: The SOUND CARD settings that
you have selected in the Kingmaker SETUP
.. . . .
Locate the SOUND CARD diskette that
came with your sound card.
Put the diskette in your A DRIVE and load
the program that will test your sound card
(please refer to your sound card documentation
for the exact name to type in).
After you run the sound card test, the com-
puter should give you three settings:
1. The IRQ ADDRESS,
2. The INTERRUPT NUMBER, and
3. The DMA #.
Copy these setting down.
Type C:\KING and hit the ENTER KEY.
Type INSTALL. Select the SOUND SET-
TINGS selection. When it asks for the num-
bers, enter them in the same order that you
copied them down.
Exit the install program and type KING.
The sound should work normally.
PROBLEM: ONLY PART OF MY SOUND
WORKS.
SOLUTION: If you have checked the settings
for your sound card and they seem to be cor-
rect, but your sounds are still only partially
working, you still do not have enough FREE
RAM. Return to the section called “BASE
MEMORY PROBLEMS”.
PROBLEM: MY 3.5” FLOPPY IS MY B:
DRIVE.
SOLUTION: You can install Kingmaker from
your B FLOPPY DRIVE by substituting “B:”
wherever the “A:” appears. However, IBM com-
patible computers can only RUN from your A:
DRIVE or your INTERNAL HARD DRIVE. If
you have a
5 1/4” FLOPPY DRIVE as your A:
Drive, you will have to make your boot disk on
a 5%” floppy disk.