User Guide
Now change to the command cursor. Left-click on the computer. If
you are standing too far away from an object, you will automati-
cally walk or run there when you attempt to use the object.
Walk south, moving further into the cave. Watch out for
vermin!
If you move too close to a rat, it will decide to attack you.
After it moves up to you and bites, combat will start. Notice that
the combat buttons in the lower right-hand corner of the interface
bar open up. It’s now combat! Left-click on the pistol. The cursor
will change to a target and the rat will be outlined in red. Move
the target cursor over the rat. The number next to the cursor is
how likely you are to hit it. It should be a pretty big number. Left-
click the mouse button to shoot the rat. The closer you are to your
target, the easier it is to hit them with a ranged weapon.
If you miss it, or it takes the bullet but doesn’t die, click on the
big red button that is attached to the button with the pistol. It
should change the active item from the pistol to the brass knuck-
les. Left-click on the brass knuckles to attack with them. Target
the rat again. You can continue to attack until you run out of
action points. The number of action points you have remaining is
displayed by the row of green lights above your weapon. The cost
to use a weapon is displayed in the lower left-hand side of the
weapon button. When you have just a few action points remain-
ing, end your turn by clicking on the END TURN button.
Everyone else involved in the combat will get a chance to act, and
then it will be your turn again. When your turn starts, your action
points are restored.
If the rat dies, combat will end. If the rat lives after your
attacks, it will get another chance to attack you. You know it is the
rats turn when the lights on the interface bar turn from green to
red. Don’t worry, you’ll get a turn soon enough. If the rat starts to
VDSG – RESTRICTED – VTB-OO1-13
RESTRICTED 2—3
2
Figure 2-4: The combat button. The END TURN
button will end your current turn. The END CMBT
button will attempt to stop the combat. If there are
hostile creatures still involved, the fight will continue!










