User Guide

14—Dyno2000 Advanced Engine Simulation
All Components
Selected
Category
Incomplete
Program Overview
Component Status Boxes
(detailed information on menu functions is provided in the next section, begin-
ning on page 20):
File—Opens and Saves dyno test files, exports DOS Dyno files to other
DeskTop software, prints engine components and power curves, allows the
quick selection of the most recently used Dyno files, and contains an exit-
program function.
Edit—Clears all component choices from the currently-selected engine (indi-
cated by the Engine Selection Tab currently in the foreground; see Engine
Selection Tabs, below).
View—Allows you to turn the Toolbar, Status Bar and Workbook layout on
(default) or off.
Simulation—Run forces an update of the current simulation. Auto Run
enables or disables (toggles) automatic simulation updates when any engine
component is modified.
Units—Selects between US and Metric units.
Tools—Opens the Iterative Testing window or selects one of the build-in,
engine-math calculators.
Window—A standard Windows menu for arranging and selecting engine
display windows.
Help—Gives access to this Users Guide, and other program help features.
3) The Engine Component Categories are made up of the following groups:
Program Menu Bar
Program Menu Bar contains eight pull-
down menus that control overall program
function.
A Status Box is located in the upper left
corner of each Component Category.
These boxes either contain a red boxed
X, indicating that the category is not
complete (inhibiting a simulation run), or
a green-boxed check-mark ✔, indicating
that all components in that category
have been selected