Full Product Manual

4
2. GENERAL INFORMATION
This manual provides information relating to the installation, utilization and maintenance of the Pool Filter System. The pump included
with the filtration system is a horizontal, self-priming centrifugal pump. For the pump to function correctly, the water temperature must
not exceed 104°F/40°C.
How Sand Filtration Works
The Pool Filter System is designed to use special silica sand to remove dirt particles from pool water. Filter sand is loaded into the filter
tank and functions as a permanent dirt and debris removing medium. Pool water, which contains dirt particles, is pumped through
the intake hose leading from the pool to the filter tank and is directed by the filter 4 way valve to the top of the filter tank. As water
is pumped through the filter sand, dirt particles are trapped by the bed of sand and filtered out. The cleaned/filtered water is then
returned from the bottom of the filter tank, through the control valve and back to the pool through the return hose. This sequence is
continuous and automatic and provides total recirculation of pool water through your filter and hose connections.
After a period of time, the accumulated dirt in the filter causes a resistance to the flow of water and an increase in pump pressure (psi).
When this happens, it is time to clean (backwash) the filter. When in backwash mode, the water flow is automatically reversed through
the filter so that it is directed to the bottom of the tank, up through the sand, which flushes any trapped dirt and debris out through
the waste port.
Powering the Filter Pump
It should be noted that the Pool Filter System does not have an on/off switch. Rather, power to the filter pump is connected and
disconnected by means of plugging in and unplugging the power cord from the power source. It is important that you read and follow
the instructions on proper power supply sources (see Section 5, Power Source Requirements) to avoid overloading the pump motor
and/or electric shock.
Sand & Initial Preparation
The Pool Filter System requires a specific type of sand (not included) for optimum operation: namely, silica sand with a particle size
of 0.45 mm - 0.55 mm. You can purchase this sand at most pool supply stores. While the sand will come packaged, it is important that
the sand be cleaned prior to running the filter system in filtration mode (see Section 9, Filter Operations).
Installation
Read and understand this manual carefully before installation. Failure to follow all instructions may result in electric shock, serious
personal injury or death.
1. SAFETY WARNINGS
READ ALL WARNINGS BELOW. FAILURE TO DO SO COULD RESULT IN SERIOUS PERSONAL INJURY OR DEATH.
• For use with above-ground pools only.
• Do not block inlet or outlet ports.
• Connect ONLY to a Ground-Fault Circuit Interrupter (GFCI) power outlet. Consult a qualified, professional
electrician for safe and proper installation of the required electrical outlet.
• Incorrectly installed equipment may fail, causing severe injuries or damage to the pump-filter system.
• Never place or submerge the filter and/or pump in water.
• NEVER use the 4 way valve lever as a handle to carry or lift the filter.
• NEVER change the position of the 4 way valve while the system is operating. ALWAYS unplug the system
first.
• Never PLUG or UNPLUG this unit from an electrical source while standing in water or with wet hands.
• NEVER service this unit with the electrical power cord connected.
• Use only Spa and Pool Lubricant. Do not use any petroleum based lubricant. Petroleum based products
will destroy plastic parts.
• KEEP CHILDREN AWAY from all electrical equipment.
• NEVER ALLOW CHILDREN TO OPERATE THIS EQUIPMENT.
THESE SAFETY WARNINGS ARE NOT INTENDED TO INCORPORATE ALL POSSIBLE INSTANCES FOR RISK
AND/OR SEVERE INJURY.