Full Product Manual

Step 1B

Step 1A

Gasket

(inside tank)

Pump

Gasket

(outside tank)

Drain Cap

Strainer Lid

Strainer Basket

Strainer Housing

Threaded Collar

Stainer

Housing

Forward

Groove

Screws &

Washers

Step 2B

7. ASSEMBLY INSTRUCTIONS (some parts may be pre-assembled)

Step 1: Motor Assembly

Step 2: Tank Assembly

A. Installing the drain valve.

1. Place a gasket onto the threaded body of the drain valve. Place the valve

through the drain hole in the bottom of the tank (from the inside, threaded section

to the outside).

2. Place a gasket on the outside of the drain valve, pressing it to the tank and screw

on the threaded collar.

3. Ensure all of the components are tight, then screw the drain cap onto the valve.

B. Place the filter tank into the notch lo-

cated in the base plate.

A. Secure the pump to the filter base with

the mounting screws. The side of the pump

WITHOUT the metal ID plate should face

towards the groove.

B. Place the strainer basket into the strainer

housing. Be sure that the opening in the

basket is aligned with the opening in the

housing. Secure lid.

Note: The filter system should be in its

permanent location before filling the

tank with sand. Otherwise the unit may

difficult to move.

Step 2A