Specifications

Reposition the Antenna Module clipped to the center edge of the trunk well (see FIG 16),
to the right side of the wire harness (see FIG 17).
Position the Rear Mounting Bracket on the edge of the trunk well.
Trim matting as required so bracket makes contact with the metal car floor (see FIG.
18).
The center notch & front edges of the bracket are formed to align with beads in the
trunk floor. Transfer 2 hole locations & drill out using 9/32" drill bit. Attach the bracket
using (2) 1/4-20 screws & nuts.
Note: Vehicles shipped with a full sized spare tire will have an existing hole for
mounting the left side hole in the bracket. Drilling will be required for the right side
hole only. Remove the clip-on nuts to enable use of 1/4-20 screws & nuts.
Drill
9/32" Drill Bit
Ratchet Wrench
7/16" Socket
7/16" Wrench
Knife
7 of 9
Installing Lower Tray Assembly - 7160-0020
FIG. 16
FIG. 17
FIG.18