Full Product Manual

Initial steps for all models:

1. Slide the finial Part (A) on top of Part (B), tighten it with the set screw.

Allen wrench is provided.

2. Install GS Solar LED Light Bulb into Part (B)

3. Attach Part (B) to Part (C) and secure it with provided screws and nuts

NOTE: When installing the GS Solar LED Bulb,

hold it from its silver base not by the glass

GS-178F (3" Fitter Mount)

NOTE: If you are replacing an existing gas/electric post light,

you must consult a certified technician to disconnect them

before installation.

1. Slide Part (C) on top of Part (F), tighten it with the set

screw. Allen wrench is provided.

2. Attach to your existing 3” post using the screws provided.

GS-178P (Pier Mount)

1. Use an electric drill to make four holes in the desired

surface. Place provided anchors into the holes. Place the

base of the lamp (E) in line with the holes and attach with

the provided screws.

2. Slide Part (C) on top of Part (E), tighten it with the set

screw. Allen wrench is provided.

GS-178W (Wall Mount)

Note: Installing the light on a wall may limit the solar panel for sun exposure. Make

sure the lamp is mounted so direct sun exposure is available.

1. Use an electric drill to make two holes in the wall and

place provided anchors into holes. Place the wall bracket

Part (D) in line with the holes and attach with the

provided screws.

2. Slide Part (C) on top of Part (D), tighten it with the set

screw. Allen wrench is provided.