Instructions / Assembly

5. Operation Figure 6
A. Plug the solar module cord into the "SP”
(Solar Panel) Socket located at the bottom of the light.
B. Pull the pull cord once to switch On the light, pull again
to switch Off the light.
REMEMBER TO SHUT OFF THE LAMP WHEN
LEAVING THE SHED TO PRESERVE BATTERY CHARGE
6. Secondary Light (Model: GS-16B2 only)
A. Follow the Light Installation (#4) to install the secondary light on the wall.
B. Make sure the extension 16ft wire (included) can reach the main light
C. Connect the extension wire into the “Ext” (Extension Socket) located at the
bottom of the main light. The other end to the Secondary light.
D. The switch cord on the main light operates both lights.
6. Maintenance
Clean the solar module with a damp towel to guarantee optimum performance of
the solar panel. Do not use any type of solvent for cleaning and be careful not to
put too much pressure on the module while cleaning.
7. How to replace battery
A. Remove the protective lens by turning it counterclockwise.
B. Unscrew the battery door screw and take the cover out.
C. Replace it with 4.8V/2000mA and reassemble in reverse
procedures.
NOTE: The performance of "Light my Shed™ IV" will vary with the time of year.
The duration of the light will be longer when the solar panel has had a full day in
the sun rather than a day in overcast weather.
WINTERTIME TIPS: Keep snow and debris off the solar panel so the batteries can
recharge. If the solar panel is covered with snow for an extended period of time,
after the snow melts, allow all the batteries to charge in full, direct sunlight for at
least 6 hours to their maximum capacity.
WARNING: Please keep out of reach of children.