Full Product Manual

Installation Instructions

GS-114P (Fig. 3)

1. Use a drill to make two holes in the desired surface,

2. Place the white screw anchors into the drill holes, place the lamp in line with the

holes and screw down with the provided screws.

Note: There are specific types of screws for specific surfaces. If unsure of the

appropriate type of screw to use on your desired surface please consult a

professional.

GS-114W (Fig. 4)

Note: For best results locate your solar lamp facing the south.

1. Use electric drill to make two holes in the wall, place provided anchors into holes,

place the wall bracket in line with the holes and screw the provided screws.

2. Assembly part (A) into the wall bracket by turning it using the screw provided.

GS-114F (Fig. 5)

Note: If you are replacing an existing gas/electric post light, you must consult a certified

technician to cancel them before installation.

1. Position Part (C) on top of the existing 3” post and tighten it using the screws

provided.

2. Screw in part (A) into part (C) using the screw provided.

Fig. 3

Fig. 5

Fig. 4