Full Product Manual

Operation Instructions

1. Remove the Top part (B) from Body part (C) by

unscrewing the 2 screw caps. Turn the

operation switch (Fig. 2) to either High or Low

position according your preferences. The Solar

Lamp will automatically operate dusk to dawn.

2. Install the new GS Solar LED Light Bulb by

turning it into the bulb socket located at the top

of the light clockwise.

NOTE: When installing the GS Solar LED Bulb,

hold it from its silver base not by the glass

[Fig.3]

3. Reattach the Top part (B) to the Body part (C)

and secure with the 2 screw caps.

Installation Instructions

1. Install finial by screwing part (A)

on the Top part (B) (Fig. 1).

GS-106B-P

1. Screw in part G into part C as shown in Fig. 1.

2. Use a drill to make two holes in the desired surface,

3. Place the white screw anchors into the drill holes, place the lamp in line with the holes

and screw down with the provided screws.

Note: There are specific types of screws for specific surfaces. If unsure of the appropriate type

of screw to use on your desired surface please consult a professional.

GS-106B-W

NOTE: For best results locate your solar lamp facing the south.

1. Screw part E into part D as shown in Fig. 1.

2. Screw part C (full lamp) into part D.

3. Remove the silver back bracket by removing the 2 screw caps on the front face

of the wall mount.

4. Screw the silver bracket onto the desired surface.

5. Place lamp onto bracket and replace 2 wall mount screw caps.

GS-106B-F

NOTE: If you are replacing an existing gas/electric post light, you must consult a

certified technician to cancel them before installation.

1. Screw part F into part C as shown in Fig. 1.

2. Position Part (F) on top of the existing 3” post and tighten it using the screws provided.

Fig. 2

Fig. 3