Instruction manual

– Cleaning the micro-filter will not restore its original colour, but it will restore its filtration
properties.
– Neglecting the micro-filter cleaning may lead to breakdown of the vacuum cleaner!
– Make sure that the contact surfaces and the sealing elements are functional.
– We recommend replacing the micro-filter once a year or when it cannot be cleaned
properly or if it is damaged.
V. MAINTENANCE
Unplug the battery charger from the appliance before any maintenance. Store the vacuum
cleaner at a dry place, far enough from heat sources (e.g. fireplace, stove, heating
element) and protect it against weather conditions (e.g. rain, sunshine). Treat the surface
of the vacuum cleaner and the battery charger (only when disconnected from the electric
socket) with a soft and wet cloth, do not use abrasive and aggressive cleaning agents!
Never dry plastic moldings over a heat source (e.g. heater, electric/gas stove).
Floor nozzle with rotation brush
After any vacuuming it is recommended to check visually the brushes or collectors for
possible impurities. If you find some impurities, remove them in the way specified below.
Cut threads and hair with scissors and remove them. If hair or threads are twisted around
the mounting of the drive shaft and if they cannot be removed in the way described above,
the impurities have to be removed by dismantling the nozzles. Unscrew the bolt in the
lower part and remove the cover. Now you can remove the brush from its position and
clean it. Insert the brush to the nozzle in the opposite direction (you will hear a snapping
sound) and secure it properly with a lid.
Storage
Store the appliance thoroughly clean on a dry, dustless place out of reach of children and
persons sui juris. The accessories may be stored in the back of the charging stand C or in
the storage space C1 (Fig. 6). Do not put the assembled rod vacuum cleaner on an uneven
surface! The cleaner must be placed on a flat surface where there is no danger of knocking
over.
25
GB
/ 43