User's Manual

User Manual Gallagher SmartReader BR Series
68
- The "Power" LED illuminates when power is supplied to the adaptor.
- The Bluetooth light flashes when a wireless connection is active.
- The "Mode" LED (middle LED) only illuminates during configuration.
Pairing the RS-232 Adaptor with your reader
The RS-232 Adaptor must be paired with your individual SmartReader, i.e.
the adaptor must be uniquely identified by your reader.
This is achieved by assigning your SmartReader "MAC address" to the
adaptor. Other Bluetooth devices (including other readers working in the
immediate area) will then be of no concern to your operation.
The pairing process must be carried out by your Gallagher distributor. If you
have received the Bluetooth adaptor with your reader, the pairing should
already be in effect. If not, take your reader and your adaptor to your nearest
distributor for pairing.
Bluetooth USB Adaptor
Introduction
A Bluetooth USB adaptor is available from your Gallagher distributor to allow
a Bluetooth enabled SmartReader to communicate with a computer.
This section describes how to install a Bluetooth USB adaptor to a USB port,
to enable your computer to make a wireless communication with any
Bluetooth device, including a Gallagher SmartReader.
The wireless connection can be used to download tag numbers to MyScale
Pro or to configure the reader with the software supplied on the MyScale Pro
CD.
Many modern computers are manufactured "Bluetooth enabled" and this
accessory is not required for those models.
Compatibility
The Computer must be running the Windows XP operating system and have
one available USB port.
MyScale Pro Version 2.5.1 or later must be installed on the computer.
Installing and connecting the USB Adaptor
1. Insert the adaptor into the USB port. This will be detected automatically.
2. After a period of configuration the Bluetooth icon will appear in the
taskbar notification area.