User's Manual

Page 4
3E4289 Gallagher T11 Reader | Edion 1 | August 2016
Copyright © Gallagher Group Limited
1 Introducon
The Gallagher T11 Reader is a mobile credenal and smart card proximity reader. It can be installed as
either an entry reader or exit reader. It can be mounted on a vercal, rectangular 50 mm x 75 mm (2" x
3") ush box with mounng holes spaced at a nominal 85 mm (3.25").
The reader sends informaon to the Gallagher Controller and acts upon informaon sent from the
Gallagher Controller. The reader itself does not make any access decisions.
The reader is available in eight variants. The card technologies for each variant are shown below.
Reader Product codes Supported card technologies
T11 Mifare Reader Black
T11 Mifare Reader White
C300410
C300411
Mifare DESFire EV1, Mifare Plus and
Mifare Classic
T11 Mul Tech Reader Black
T11 Mul Tech Reader White
C300430
C300431
Mifare DESFire EV1, Mifare Plus, Mifare
Classic and 125 KHz cards
T11 PIV Reader Black
T11 PIV Reader White
C305410
C305411
PIV, PIV-I, Mifare DESFire EV1, Mifare
Plus and Mifare Classic
T11 PIV Reader - Mul Tech Black
T11 PIV Reader - Mul Tech White
C305430
C305431
PIV, PIV-I, Mifare DESFire EV1, Mifare
Plus, Mifare Classic and 125 KHz cards
The reader can be connected as an HBUS Reader or Cardax IV Reader. An HBUS Reader uses the HBUS
communicaons protocol to communicate with the Gallagher Controller. A Cardax IV Reader uses the
Cardax IV Reader communicaons protocol to communicate with the Gallagher Controller.
IMPORTANT: HBUScompability
HBUS communicaons are supported with sites running Gallagher Command Centre vEL7.00 soware
(or later).
IMPORTANT: MulTechreaders
Using dual technology 125/Mifare cards with Gallagher Mul Tech readers may cause both card
technologies to be read, resulng in double card badges and unusual reader feedback. Gallagher
strongly recommends against using dual technology 125/Mifare cards with Mul Tech readers for sites
running pre-Command Centre v7.00 soware. From Command Centre v7.00, a site may specify which
technology a Mul Tech reader should read o a dual technology card.
IMPORTANT: PIV readers
Gallagher PIV readers connect to the Gallagher Controller 6000 High Spec PIV (C305101) only (referred
to as the Controller). Gallagher PIV readers can only be used with sites running Gallagher Command
Centre vEL7.10 soware (or later). Gallagher PIV readers are connected as HBUS Readers only.
IMPORTANT: Mobilecredenalreaders
Gallagher Mul Tech readers support Gallagher mobile credenals using Bluetooth® wireless
technology. Mobile credentials are supported with sites running Gallagher Command Centre vEL7.60
soware (or later). To use mobile credenals, the Mul Tech reader must be connected as an HBUS
Reader.