User's Manual

Page 4
3E4290 Gallagher T12 Reader | Edion 1 | August 2016
Copyright © Gallagher Group Limited
1 Introducon
The Gallagher T12 Reader is a mobile credenal and smart card proximity reader. It can be installed as
either an entry reader or exit reader. It can be mounted on a BS 4662 Brish Standard square ush box.
The reader sends informaon to the Gallagher Controller and acts upon informaon sent from the
Gallagher Controller. The reader itself does not make any access decisions.
The reader is available in four variants. The card technologies for each variant are shown below.
Reader Product codes Supported card technologies
T12 Mifare Reader Black
T12 Mifare Reader White
C300420
C300421
Mifare DESFire EV1, Mifare Plus and
Mifare Classic
T12 Mul Tech Reader Black
T12 Mul Tech Reader White
C300440
C300441
Mifare DESFire EV1, Mifare Plus, Mifare
Classic and 125 KHz cards
The reader can be connected as an HBUS Reader or Cardax IV Reader. An HBUS Reader uses the HBUS
communicaons protocol to communicate with the Gallagher Controller. A Cardax IV Reader uses the
Cardax IV Reader communicaons protocol to communicate with the Gallagher Controller.
IMPORTANT: HBUScompability
HBUS communicaons are supported with sites running Gallagher Command Centre vEL7.00 soware
(or later).
IMPORTANT: MulTechreaders
Using dual technology 125/Mifare cards with Gallagher Mul Tech readers may cause both card
technologies to be read, resulng in double card badges and unusual reader feedback. Gallagher
strongly recommends against using dual technology 125/Mifare cards with Mul Tech readers for sites
running pre-Command Centre v7.00 soware. From Command Centre v7.00, a site may specify which
technology a Mul Tech reader should read o a dual technology card.
IMPORTANT: Mobilecredenalreaders
Gallagher Mul Tech readers support Gallagher mobile credenals using Bluetooth® wireless
technology. Mobile credentials are supported with sites running Gallagher Command Centre vEL7.60
soware (or later). To use mobile credenals, the Mul Tech reader must be connected as an HBUS
Reader.
2 Beforeyoubegin
2.1 Shipment contents
Check the shipment contains the following items:
• 1 x Gallagher T12 Reader facia assembly
• 1 x Gallagher T12 Reader bezel
• 1 x M3 Torx Post Security screw
• 2 x M3.5 Phillips drive xing screws
• 4 x 25 mm No.6 self tapping, pan head, Phillips drive xing screws
• 4 x 40 mm No.6 self tapping, pan head, Phillips drive xing screws