User's Manual

Table Of Contents

Page 8

3E4290 Gallagher T12 Reader | Edion 1 | August 2016

2. Run the building cabling out through the centre hole and through the reader bezel.

3. Secure the bezel to the ush box using the two M3.5 screws provided. It is important the bezel

of the reader is ush with and ght against the mounng surface.

If you are not mounng to a ush box, secure the bezel to the mounng surface using the four

xing screws provided.

Note: It is strongly recommended that you use the screws provided. If an alternave screw is

used, the head must be no larger nor deeper than that of the screw provided.

Note: Ensure the centre hole allows the cable to run freely out through the mounng surface, so

that the reader facia can clip into the bezel.

Bezel

Building cable

M3.5 screw

4. Connect the reader tail extending from the facia assembly to the building cable. Connect the

wires for the appropriate reader you wish to interface, either an HBUS Reader or a Cardax IV

Reader, as shown in the following diagrams.

Note: Mobile credenal readers must be connected as HBUS Readers.

An HBUS Reader connects to a Gallagher Controller 6000, Gallagher 4H/8H Module (aached to

a Controller 6000) or a Gallagher HBUS Door Module (connected to a Controller 6000).

A Cardax IV Reader connects to a Gallagher Controller 6000, Gallagher 4R/8R Module (aached

to a Controller 6000), Gallagher GBUS Universal Reader Interface (Gallagher GBUS URI), Gallagher

Controller 3000-8R or 3000-4R, Gallagher Local Bus Universal Reader Interface (Gallagher URI) or

a Gallagher Local Bus Reader I/O Interface.

HBUS Reader connecon: HBUS Reader terminated:

Posive Red

Negave Black

HBUS Terminaon Orange

HBUS A Green

HBUS B Brown

CDXIV TX White

CDXIV RX Blue

HBUS Reader