User's Manual

Table Of Contents

Page 7

3E4288 Gallagher T10 Reader | Edion 1 | August 2016

3 Distancebetweenreaders

The distance separang any two proximity readers must not be less than 200 mm (8 in) in all direcons.

When mounng a proximity reader on an internal wall, check that any reader xed to the other side of

the wall is not less than 200 mm (8 in) away.

200 mm

4 Installaon

ATTENTION: This equipment contains components that can be damaged by

electrostac discharge. Ensure both you and the equipment are earthed before

beginning any servicing.

The Gallagher T10 Reader is designed to be mounted on any solid at surface. However installaon on

metal surfaces, parcularly those with a large surface area will reduce read range. The extent to which

the range is reduced will depend upon the type of metal surface.

The recommended mounng height for the reader is 1.1 m (3.6 ) from the oor level to the centre of

the reader device. However this may vary in some countries and you should check local regulaons for

variaons to this height.

1. Use the reader bezel as a guide to drill all three holes. Drill the 13 mm (1/2 inch) diameter centre

hole (this is the centre hole for which the building cable will exit the mounng surface) and the

two xing holes.

2. Run the building cabling out through the centre hole and through the reader bezel.

3. Secure the bezel to the mounng surface using the two xing screws provided. It is important

the bezel of the reader is ush with and ght against the mounng surface.

Note: It is strongly recommended that you use the screws provided. If an alternave screw is

used, the head must be no larger nor deeper than that of the screw provided.

Note: Ensure the centre hole allows the cable to run freely out through the mounng surface, so

that the reader facia can clip into the bezel.