User's Manual

Page 1
Part Number: 3E2453 | Edi on 8
November 2012
The Gallagher T10 Mifare Reader
The Gallagher T10 Mifare Reader is a smart card proximity reader. It can be installed
as either an entry reader or exit reader.
The reader can read: Mifare DESFire EV1, Mifare Plus and Mifare Classic cards.
The reader sends informa on to the Gallagher Controller and acts upon informa on
sent from the Gallagher Controller. The reader itself does not make any access
decisions.
The Gallagher T10 Mifare Reader uses the Cardax IV communica ons protocol to
communicate with the Gallagher Controller.
Note: A French transla on of this document can be downloaded from the Gallagher
Support Site: hƩ p://support.gallagher.co
Before you begin
Shipment Contents
Check the shipment contains the following items:
1 x Gallagher T10 Reader facia assembly
1 x Gallagher T10 Reader base
1 x M3 Torx Post (T10) Security screw
2 x 25 mm No.6 self tapping, pan head, Phillips drive xing screws
2 x 40 mm No.6 self tapping, pan head, Phillips drive xing screws
InstallaƟ on Note
Gallagher T10 Mifare Reader
ATTENTION: This equipment contains components that can be damaged
by electrosta c discharge. Ensure both you and the equipment are earthed
before beginning any servicing.

Summary of content (11 pages)