User's Manual

R5 | Part Number: 3E2512 | 5
Installation Note | Gallagher T12 Reader
Positive Red
Negative Black
Reserved Orange
Reserved Green
Reserved Brown
CDXIV TX White
CDXIV RX Blue
Cardax IV Reader
Fit the facia assembly into the base by clipping the small lip, into the top of 5.
the base and holding the top, press the bottom of the facia assembly down
into the base.
Insert the M3 Torx Post Security screw (using a T10 Torx Post Security screwdriver) 6.
through the hole at the bottom of the base to secure the facia assembly.
Note: The recommended torque for the security screw is 0.7Nm (0.5 lb/ft). It
is important not to exceed the maximum torque of 1.5Nm (1.1 lb/ft).
Facia
Reader tail
Connection
Fit screw to secure
facia to base
Removal of the facia assembly is a simple reversal of these steps.7.
Connections
A Gallagher T12 Reader can connect to one of the following devices using the
“Cardax IV Reader” communications protocol:
Cardax FT Reader Module (for the Controller 6000)•
Cardax FT GBUS Universal Reader Interface (Cardax FT GBUS URI)•
Cardax FT Controller 3000-4R or 3000-8R•
Cardax FT Universal Reader Interface (Cardax FT URI)•
Cardax FT Reader I/O Interface•