User's Manual

Part Number: 3E2453 R1 | 5
Installation Note | Gallagher T10 Mifare Reader
Insert the M3 Torx Post Security screw (using a T10 Torx Post Security 6.
screwdriver) through the hole at the bottom of the base to secure the
facia assembly.
Note: The recommended torque for the security screw is 0.7Nm
(0.5 lb/ft). It is important not to exceed the maximum torque of
1.5Nm (1.1 lb/ft).
Fit screw to secure facia to base
Facia
Building
cable
Reader
tail
Connection
Removal of the facia assembly is a simple reversal of these steps.7.
Connections
A Gallagher T10 Mifare reader can connect to one of the following devices
using the “Cardax IV Reader” communications protocol:
Cardax FT Reader Module (for the Controller 6000)•
Cardax FT GBUS Universal Reader Interface (Cardax FT GBUS URI)•
Cardax FT Controller 3000-4R or 3000-8R•
Cardax FT Universal Reader Interface (Cardax FT URI)•
Cardax FT Reader I/O Interface•