User's Manual

Installation Note

Part number 3E0477 R2 1

March 2004

3E0477 R1

February 2004

Introduction

The Cardax 125 Encoder is used in conjunction with the Cardax Encoder III

software, for encoding and re-encoding Cardax 125 Series proximity cards.

Note:

The Cardax 125 Encoder will only operate correctly with the Cardax Encoder

III software installed.

Before you begin

Unpack the Cardax 125 Encoder and check the shipment contains the

following items:

• 1 x Cardax 125 Encoder

• 1 x Cardax 125 Encoder Installation Note (part number 3E0477)

• 1 x DB9 Female / Female cable

Power Supply Requirements

The Cardax 125 Encoder requires a supply of 13.6 V DC ± 15% with current at

200 mA per Encoder.

Cardax 125 Encoder

PAGE 1
Installation Note Cardax 125 Encoder 3E0477 R1 February 2004 Introduction The Cardax 125 Encoder is used in conjunction with the Cardax Encoder III software, for encoding and re-encoding Cardax 125 Series proximity cards. Note: The Cardax 125 Encoder will only operate correctly with the Cardax Encoder III software installed.
PAGE 2
Approvals and Standards This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.