Specifications

FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions:(1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance
between 20cm the radiator your body.
Shenzhen Smart-eye Digital Electronics Co., Ltd
2F, Block 1, Shangrong Industrial Zone, No.2 Baolong Road
5, Longgang, Shenzhen, China
NB Warning:
Manufacturer's Name: Shenzhen Smart-eye Digital Electronics Co., Ltd
Sample Description: Battery IP Camera Trade Mark: /
Model number: Y1(763),Y2(795), Q7(639), G3, R11, R12, 640, 641, 642, 764
Operating Temperature: 10° C to 50° C Wireless specification:
2.4G Wi-Fi: Max power 16.78dbm in frequency band 2412 2472MHz, Limit 20dBm.
This product is a fixed location. To comply with RF exposure requirements, a minimum
separation distance of 20cm must be maintained between the user’s body and the device,
including the antenna. Use only the supplied or an approved antenna.
This device in compliance with the essential requirements and other relevant provisi ons of
Directive 2014/53/EU. All essential radio test suites have been carried out.
The device complies with RF specifications when the device used at 20cm from your body.
This product can be used across EU member states.
This device was tested for typical fixed location operations. To comply with RF exposure
requirements, a minimum separation distance of 20cm must be maintained between the
user’s body and the IP camera, including the antenna.
This device in compliance with the essential requirements and other relevant provisions of
UK Radio Equipment Regulations (SI 2017/1206); UK Electrical Equipment (Safety)
Regulations (SI 2016/1101); and UK Electromagnetic Compatibility Regulations (SI
2016/1091). All essential radio test suites have been carried out.
Product Name: IPCAM
Model: Y1(763)
https://www.wansview.com/cn/proinfo.aspx?proid=48&categoryid=1&aids=2
Note: Both trademarks belong to the same manufacturer