Service Manual

INSTALLATION
2-2
Part No. 001-3474-002
Pin 11 (Carrier Detect) - This output is not used at this time.
Pin 12 (RSSI Output) - The RSSI (Receive Signal Strength Indicator) output provides a voltage that increases in
proportion to the strength of the RF input signal.
Pin 13 (Rx Output) - The data output level is 600-1200 millivolts P-P (200-400 mV RMS) with a modulation signal
of 1 kHz at 60% of maximum deviation. The output is DC coupled and referenced to +2.5V DC. Load impedance
should be 10k-100k ohms.