This symbol indicates that dangerous voltage constituting a risk of electric shock is present within this unit. This symbol indicates that there are important operating and maintenance instructions in the literature accompanying this unit. WARNING! USING THIS SYSTEM AT EXCESSIVE VOLUMES CAN CAUSE PERMANENT HEARING DAMAGE. USE AS LOW A VOLUME AS POSSIBLE. In order to use this system safely, avoid prolonged listening at excessive sound pressure levels.
ANY SPOT WIRELESS IN EAR MONITOR Table of Contents 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. Page Introduction....................................................... 1 Safety..................................... Inside front cover Description AS1000T.........................................2 Description AS1000R........................................4 Setup.................................................................. 7 Specification AS1000R.......................................
AS-1000 INTRODUCTION GALAXY AUDIO ANY SPOT AS-1000 WIRELESS PERSONAL MONITOR SYSTEM Introduction Thank you for purchasing the Galaxy Audio Any Spot! The AS1000 is a wireless in-ear monitor system, which consists of the AS-1000T transmitter and the AS-1000R receiver. This in-ear monitor system operates in the UHF Frequency band and utilizes a Phase Locked Loop (PLL) synthesizer control for improved reception and channel selection.
AS-1000T AS-1000T Transmitter Features The AS-1000T is a low power FM broadcasting transmitter. It can simultaneously transmit stereo music (from sources such as CD players, MP3 players, etc.) and vocal audio (from wired or wireless microphone systems). It can also be interfaced with a mixing console to transmit an entire monitor mix to the performer. Up to 64 selectable frequencies are available to set up a multi-frequency broadcasting system while avoiding interference.
AS-1000T PRODUCT DESCRIPTION 4 1 5 6 7 8 9 Front panel 3 2 10 11 12 13 14 15 Rear panel 1. POWER: On/Off push button switch. 2. GR: Rotary switch used to select frequency group. 3. CH: Rotary switch used to select frequency channel. 4. LED display: Indicates the current frequency group and channel selected on the transmitter. 5. CH 1 MIC/LINE: Adjusts the volume of the ¼" XLR MIC/LINE input. 6. CH 2 LINE: Adjusts the volume of the stereo RCA and STEREO 1/4" LINE IN inputs. 7.
AS-1000R 9. HEADPHONE JACK: 1/4" stereo jack for headphones. This jack is used to monitor the audio signal from the transmitter location. 10. RF OUT: TNC socket for installation of antenna. 11. CH 1 MIC/LINE INPUT: Balanced 1/4" XLR combo jack for microphone level (XLR), or line level (1/4") signals. 12. STEREO/MONO: Switch used to select stereo or mono mode of CH 2 RCA and 1/4" LINE IN inputs. 13. CH 2 LINE IN: Stereo RCA jacks for mono or stereo audio input. 14.
AS-1000R PRODUCT DESCRIPTION 4 3 2 1 10 5 11 GR 3 4 7 6 5 6 CH. 1 2 GR. 1 2 8 7 CH 3 4 8 7 6 5 1. POWER: On/Off slide switch. 2. MULTI-COLOR LED INDICATOR: A. When the power is first switched on, the LED flashes RED, and then fades out. B. A constant GREEN LED indicates a signal from the transmitter is present plus fully charged batteries. C. A constant AMBER LED indicates the batteries are low. (Time to replace the batteries). D.
AS-1000R 3. VOLUME CONTROL: Adjusts the volume of the signal present at the ear bud jack (#6). 4. 1/4" WAVE ANTENNA 5. 1/8" STEREO RECORDING OUTPUT: Provides a stereo line level signal to recording or other equipment. (Not affected by the volume control #3). 6. 1/8" STEREO EAR BUD OUTPUT: Provides a stereo signal to the ear buds. 7. BATTERY COMPARTMENT DOOR RELEASE. 9 8 8. BATTERY CHARGER INPUT: For use with the optional battery charger (AS-DCC). (Use only with rechargeable type batteries.) 9.
AS-1000 SYSTEM SETUP & OPERATION 1. 2. 3. 4. 5. 7 Make sure that both the AS-1000T Transmitter and AS1000R Receiver power switches are in the off position before beginning this procedure. Install 2 fresh AA batteries into the AS1000R. Attach headphones to the green headphone jack and turn the headphone volume control to minimum. Move the power switch to the ON position. The LED indicator should illuminate Red for a few seconds and then go out.
AS-1000 signals use the ¼” (MIC) input jack. For Stereo Line level signals use the Stereo RCA jacks. (The RCA jacks may also be used in Mono by sliding the Stereo/Mono switch to Mono mode). 6. Send audio signals from the source(s) at the approximate level that will be used during the performance. Sources may be a monitor mix from a mixing console, a CD player, or even a single microphone. 7.
AS-1000R SPECIFICATION : AS-1000R Receiver Model no. AS1000R Frequency Range UHF 682~698MHz. 64 CH Case Body-pack In Ear Monitor Oscillator PLL synthesized Receiving Mode Single channel. Diversity Frequency Stability ±0.005% Receiving Sensitivity At 5 dBuV over 80dB S/N ratio Image & Spurious 80dB minimum Rej. Selectivity > 50dB Modulation Mode FM IF Frequency 1st: 56MHz 2nd: 10.
AS-1000T SPECIFICATION SPECIFICATION : AS-1000T Transmitter Frequency range UHF 682 ~ 698MHz RF power output 100mW Frequency stability ±0.005% Maximum deviation ±48KHz with limiting compressor Spurious emission >60dB below carrier frequency T.H.D. <1% (at 1KHz) Power supply DC12 ~18V Tone key 32.768 KHz Current consumption 140mA ±10mA(100mW) Dimension W x H x D 8.31" x 1.73" x 7.1" (211 x 44 x 180mm) Design and specifications are subject to change without notice.
AS-1000 TROUBLESHOOTING Problem No Sound Sound interference Distortion 11 Solution l Make sure both the transmitter and receiver are switched on and receiving power. l Make sure the transmitter and receiver are tuned to the same frequency program number. l Make sure an audio signal is being supplied to the transmitter. Check by plugging a set of headphones into the Phones jack on the transmitter. l Make sure the receiver is within range of the transmitter.
Frequency Chart 12
AS-1000 Certification AS-1000T: Certified to FCC Parts 74, FCC ID JEBIEM-168.Meets essential requirements of European R&TTE Directive 1999/5/EC, eligible to bear CE marking. Type approved to EN 300 422 -2. Meets requirements of EMC Standard EN 301 489 Parts 1 and 9. Certified to EN 60065. AS-1000R: Approved under the Declaration of Conformity (DoC) provision of FCC Part 15. Meets essential requirements of European Union R&TTE Directive 1999/5/EC, eligible to bear CE marking. Type approved to EN 300 422 -2.
NOTES NOTES 14
ONE YEAR LIMITED WARRANTY This warranty gives you specific legal rights, and you may also have other rights which may vary from state to state. This warranty is extended to the purchaser and to any purchaser from him/her for value. GALAXY AUDIO warrants the materials and workmanship of its products for a period of one full year from the date of the original purchase. The following are not covered by the warranty: 1. Damage to or deterioration of the exterior cabinet which occurs after delivery. 2.
REGISTRATION CARD Broadcast On-Air o Production o Live Sound o Church o Recording Home/Project Studio o Commercial Studio o Post-Production/Mastering o This Galaxy Audio product will be used for: Serial number What magazines do you read?_________ _________________________________ _________________________________ __________________________________ _________________________________ _________________________________ How can Galaxy Audio better serve you? _________________________________ _________________
1-800-369-7768 www.galaxyaudio.com P.O. BOX 16285 Wichita, Ks 67216-0285 PLACE STAMP HERE V2-06202007 GALAXY AUDIO P.O.
