User's Manual

GainSpan
Confidential Page 6
Figure.2
b) TX99% command:
AT+WTX99TEST=<Channel>,<BandWidth>,<NumFrames>,<FrameLen>,<TxRate>,<GCT setting of
TxPower>,<DestAddr>,<Bssid>,<GuardInterval>,<GreenField>,<Antenna>,<Cca>,<Agc>,<ContPreambleM
ode>,<Spreader>,<Scrambler>,<Preamble>,<PreambleType>,<TestPatternType>,<PhyTestTxRate>,<ModeSe
lect>
 11b-1Mbps:
AT+WTX99TEST=1,0,99,1000,0,15,00:11:22:33:44:55,00:50:c2:5e:10:99,0,0,0,0,1,0,1,1,1,0,3,0,1
 11g-6Mbps:
AT+WTX99TEST=1,0,99,1000,0,23,00:11:22:33:44:55,00:50:c2:5e:10:99,0,0,0,0,0,0,0,0,0,0,3,3,0
 11n-MCS0:
AT+WTX99TEST=1,0,99,1000,0,23,00:11:22:33:44:55,00:50:c2:5e:10:99,0,0,0,0,0,0,0,0,0,0,3,0,2
Note: Channel:1-13; TxPower: Change the GCT setting of TxPower based on the GCT table
 Step4: AT+RESET
Note: Run this command before the next command to change channel or data rate.