INSTRUCTIONS BOOKLET US/CANADA

29
English
cation and switch on the machine again. The machine will warm up and
perform an automatic rinse cycle.
3 Before preparing any beverage, perform a manual rinse cycle. To perform
a manual rinse cycle, dispense half a tank of hot water, then prepare 2
cups of pre-ground co ee without adding ground co ee.
Note: if this operation is not complete, it is necessary to perform another
descaling procedure as soon as possible.
Warning Icons and Error Codes
Meaning of the Warning Icons
Warning icons are red. The list below reports the warning icons that the
display can show along with their meanings.
Fill the tank using running water
up to the MAX level indication.
The milk carafe is not installed.
Insert the milk carafe into the
machine.
The co ee bean hopper is empty.
Insert the co ee beans in the
co ee bean hopper.
The co ee grounds drawer is full.
Check that the machine is on. Re-
move the co ee grounds drawer
and empty it.
The brew group is not in the ma-
chine or it has not been inserted
correctly. Insert the brew group.
The brew group is clogged by cof-
fee powder. Clean the brew group.
The hot water dispensing spout is
not installed. Insert the hot water
dispensing spout.
Insert the drip tray and close the
maintenance door.
If an error is shown on the display,
refer to the “Meaning of the Error
codes” section to check the mean-
ing of the code shown and how
to proceed. You cannot use the
machine when the display shows
this icon.
Empty the co ee grounds drawer.
Wait about 5 seconds before
reinserting it.
A beverage has been selected
without the co ee bean hopper
inner lid on the machine. Place
the co ee bean hopper lid on the
machine within 30 seconds to
complete brewing.