INSTRUCTIONS BOOKLET

ENGLISH

10 Remove the container, empty it and put it back under the coffee dispensing

spout. Press OK to conrm.

11 The second stage of the cleaning cycle starts, that is the rinse cycle. This stage

lasts for 3 minutes. The display shows the rinse icon and the duration of this

stage.

Note: if the water tank is not lled up to CALC CLEAN level, it may be necessary to

repeat the rinse cycle.

12 Wait until the machine does not dispense water anymore. The descaling

procedure is nished when the display shows a tick.

13 To exit the descaling cycle, press the OK button. The machine starts warming

up and performs an automatic rinse cycle.

14 Remove the container and empty it.

15 Perform the “Weekly Cleaning of the Milk Carafe” operation to clean the carafe

after the descaling.

16 Clean the brew group as described in the “Brew Group Cleaning under Running

Water” chapter.

17 Install a new "INTENZA+" lter into the water tank.

What to do if the descaling procedure is interrupted

You can exit the descaling procedure pressing the STAND-BY button on the control

panel. In case the descaling procedure stops before its completion, perform the

following operations:

1 Empty the water tank and wash it thoroughly.

2 Fill the water tank using running water up to the CALC CLEAN level indication

and switch on the machine again. The machine will warm up and perform an

automatic rinse cycle.

3 Before preparing any beverage, perform a manual rinse cycle. To perform a

manual rinse cycle, dispense half a tank of hot water, then prepare 2 cups of

pre-ground coffee without adding ground coffee.

Note: if this operation is not complete, it is necessary to perform another descaling

procedure as soon as possible.

Note: the “INTENZA+” lter reduces the frequency of the descaling clean.

4219-450-03601 MANUAL GAG. ANIMA CLASS-PREST. EN-ES-PT.indd 24 03/12/2018 15:01:34