Use and Care Manual

46
en-us Troubleshooting
Disruption Possible cause Solution
Appliance not working, no display Plug not inserted Connect the appliance to the electricity
mains
Power failure Check whether other kitchen appliances
are working
Fuse defective Check in the fuse box whether the fuse
for the appliance is in working order
Operating error Switch off the fuse for the appliance in
the fuse box and switch it on again after
about 10 seconds
The appliance does not work, the
display shows "Device locked. Des-
caling required."
Build-up of limescale in the appliance Start the descaling program
~ "Descaling program" on page 43
Despite descaling, "Please descale"
appears on the display
Build-up of limescale in the appliance,
wrong descaler used
Use the specified descaling tablets, start
the descaling program ~ "Descaling
program" on page 43
Appliance cannot be started Appliance door is not quite closed Close appliance door
The appliance is not working and
the display does not respond. 0
appears on the display
Childproof lock activated Deactivating the childproof lock
Appliance switches off automati-
cally
Safety deactivation: the appliance has
not been operated for longer than 12
hours
Confirm the message with ™, switch off
the appliance and set it again.
Appliance does not heat up, °
appears in the display
Appliance is in the demo mode Deactivate demo mode in the basic set-
tings
Appliance will not start, a message
appears in the display
No water in the appliance Check water intake
The core temperature probe is
inserted but the + symbol is not
displayed
Moisture on the socket in the oven cav-
ity
Move the core temperature probe shaft
in and out of the socket in the oven cavity
several times
No steam visible Steam is not visible above 212° F
(100°C)
This is normal
The 3 "steam removal" symbol does
not appear
You can use the steam removal func-
tion only up to a temperature of 266°F
(130 °C)
This is normal
Powerful steam outlet at the top of
the door
The operating mode has been
changed
This is normal
Extreme amounts of steam emerg-
ing at the side of the door
Door seal soiled or loose Clean the door seal and insert it in the
groove
Humming when turned on Water outlet pump is warming up Normal operating sound
Appliance was not used for a few days Normal: automatic rinsing at start up
A wistling noise can be heard
during heating up
Noises may be produced during steam
generation
This is normal
There is a 'plop' noise during cook-
ing
Stress expansion in the event of a
large temperature difference
This is normal
Steaming is not possible Build-up of limescale in the appliance.
Appliance must be descaled to avoid
damage to the appliance
Starting the descaling
program~ "Descaling program"
on page 43
Appliance does not steam properly
any more
Appliance is clogged with scale Start the descaling program
The lighting does not work The lighting is defective Call Customer Service