Installation Instruction

Installing the appliance en-us
11
3. Undo the two screws a little, but do not completely re-
move them.
4. Adjust the appliance door using the side screw; to do
this, open the appliance door and then close it again if
necessary.
5. Check the alignment.
6. Tighten both screws.
5
7. Fit the cover cap.
8. Slide the appliance into the cabinet opening.
8.3 Combining the appliance with an oven
1. Fit the combi-steam oven first, then the oven.
2. For an installation depth of 21⅝" (550mm), position the
water hoses and the connection cable in the area of the
slanted edge on the corner of the housing.
3. Note:The rear side of BO4.. ovens has a sloped cor-
ner.
Run the inlet and outlet hose for the combi-steam oven
downwards to the connections in the rear left of the in-
stallation cabinet.
4. If the hoses are not kept in the rear-left corner of the in-
stallation cabinet, the cabinet body must be pulled for-
wards by at least 1⅜" (35mm), and side panels or fac-
ing must be used when installing the appliance above
an oven.
8.4 Combining the appliance with a warming
drawer - 24"(60 cm)
NOTICE:
Sharp edges on the appliance may damage the panel on
the warming drawer.
▶ Do not damage the warming drawer panel when sliding
the appliance in.