Installation Guide
Table Of Contents
- BS 464/465 610
- Table of ContentsInstallation instructions
- IMPORTANT SAFETY INSTRUCTIONS
- Before you beginBefore you begin
- Preparing kitchen units
- Dimensions and Cabinet Requirements
- Removing Packaging
- Install Appliance
- Customer service
- To book an engineer visit and product advice
- Table des matièresNotice de montage
- IMPORTANTES CONSIGNES DE SÉCURITÉ
- Avant de commencerAvant de commencer
- Préparation des meubles
- Exigences en matière de dimensions et d'armoire
- Pour enlever l’emballage
- Installation de l’appareil
- Service après-vente
- Antes de empezarAntes de empezar
- Preparar los muebles empotrables
- Dimensiones y requisitos del gabinete
- Quitar el embalaje
- Montaje del electrodoméstico
- Servicio de atención al cliente
8
4 Screw the appliance into place. Remove
transportation lock from the door.
Adjusting the door
For precise alignment, the appliance door can be easily
adjusted.
For this purpose, slightly pull out the appliance from the
built-in cut-out. At the top of the appliance there is an
oval opening located on the hinge side. Remove the
cover cap. Slightly loosen both screws (Inbus 5 mm),
but do not remove them!
Align the door via the lateral screw (Torx 20).
7RU [










