Installation Instructions

Fitting the upper support frame

1 Before installation, establish the total height of the

support frame.

Note: The height of the support frame can be

adjusted in steps of ¾" (20 mm).

2 Mark the positions of the six screws on the ceiling.

Note: Ensure that the support frame is in the

correct position. The appliance has one control

panel on the open side of the support frame. The

other control panel is located on the opposite side.

3 Drill the holes and push in the wall plugs so that

they are flush with the wall.

4 Use six screws to fasten the upper support frame to

the ceiling.

Fitting the lower support frame

without using an extension

1 Ensure that the lower support frame is in the

correct position.

Note: Position the open side of the lower support

frame opposite the open side of the upper support

frame.

2 Slide the lower support frame into the upper

support frame and use 16 screws to secure it at the

established total height.

Notes

‒ Select the mounting holes in such a way that a

maximum clearance is achieved between the

screws. The purpose of this is to ensure stability.

‒ Leave open at least one mounting hole between the

screws.