Installation Instructions

5
Before you begin Before you begin
Tools and parts needed
▯ Philips head screwdriver
▯ 1/8" drill bit and drill
▯ Measuring tape
Parts included
▯ Combi-steam oven
▯ 1 Torx screw
Power Requirements
The outlet must be properly grounded in accordance
with all applicable codes.
Planning notes
Door hinge not interchangeable.
Distance from furniture body to door front 1.85”
(47 mm).
Distance from furniture body to outer edge of door
handle 3.7” (94 mm) after retrofitting the handle (special
accessory).
Pay attention to the front protrusion, possibly including
the door handle, for opening drawers at the sides.
When planning a corner solution, pay attention to the
door opening angle of at least 90°.
No other electrical appliance may be integrated into the
cupboard above this appliance.
Do not install the appliance version with the control
panel on the bottom above a dishwasher. Ascending
steam from the dishwasher can damage the appliance
electronics.
You can order the following installation accessories
▯ GZ 010 011: Extension of the supply and drain hose
(length 6.6 ft / 2 m)
▯ GF 111 700: Descaling system
Provide the descaling system when connecting the
appliance if the water hardness exceeds 7 dh in order to
reduce the calcification of the appliance.
Preparing Kitchen Units Prepar i ng Kitchen Units
Units into which ovens are to be fitted must be heat-
resistant up to 195°F (90°C) and adjacent cabinets up
to 160°F (70°C).
Connection box must be outside of the installation
niche.
Perform cut-out work on the furniture before inserting
the appliance. Remove any shavings or the function of
the electrical components may be impaired.
Secure freestanding units to the wall using a standard
bracket.
Only fit the appliance up to a height that allows
accessories to be removed easily.