Use and Care Guide
Product Data Sheet: GacoFlex GacoWash
August 2016
Supersedes 3/14
Made in the USA gaco.com 800.331.0196
GACOFLEX
®
GACOWASH CONCENTRATED CLEANER
DESCRIPTION:
GacoWash is a concentrated cleaning solution for roof membranes and existing waterproof
systems. It is specially formulated to remove tough dirt, pollen, mildew and fungus.
USAGE:
GacoWash is ideal for use as a cleaning solution for aged asphalt, aged EPDM and TPO/CPA,
built-up, cap sheet, composite, concrete, fiberglass, metal, modified bitumen, torchdown, most
existing coatings and coated polyurethane foam.
COLOR:
Clear Yellow/Amber
PACKAGED PRODUCT DATA
THEORETICAL
COVERAGE:
400 sq. ft. per diluted gallon (9.84 m
2
/ L) when combined 1 part GacoWash to 9 parts water.
(Maximum coverage of 1 gallon GacoWash combined with 9 gallons water is 4,000 sq. ft.)
Note: Amount of cleaner required is job-specific; higher concentrations may be needed for adequate cleaning.
VOC:
0
FLASH POINT:
None
STORAGE STABILITY:
Five years in original unopened container.
APPLICATION
MIXING:
For general cleaning, combine 1 part GacoWash Concentrated Cleaner with 9 parts water.
Caution: Never mix GacoWash with other cleaning chemicals and always avoid contact with
chlorine-based cleaners as the combination of these cleaners may produce a toxic gas release.
SURFACE
PREPARATION:
It is extremely important to get the roof clean and dry. First remove heavy deposits of dirt,
leaves and other debris from the roof using broom or air broomer then inspect the entire roof
surface and flashings for any open seams, tears, cuts, etc. Repair these flaws so water is not
blown in under membrane during the cleaning process. Pressure wash roof with water and allow
it to dry completely. Biological Control: Areas of algae, mildew or fungus on the roof membrane
or the existing coating should be treated with a solution of 1 part household bleach and 3 parts
water, followed by a power washer rinse using clear water.
APPLICATION:
After the roof is completely dry from initial cleaning described above, apply GacoWash with a low
pressure sprayer, using a 3-4 foot (0.91-1.22 m) arc pattern. A Hudson-type agricultural sprayer,
conventional pressure sprayer or airless sprayer is recommended. Allow solution to stand for 10-15
minutes, adding a light mist of water to prevent drying. While it stands, lightly agitate any heavily
soiled areas with a broom or brush. Do not allow dirt to settle in low areas.
After application of cleaner, use a commercial power washer >3,000 psi (20.69 MPa) to remove
debris and continue rinsing until all suds are gone. Start at the lowest point of the roof and work
towards the highest point. For low-sloped roofs, work away from and then back towards roof drains.
It is important to keep the surface wet until all of the GacoWash and other residue has been
completely rinsed off and the surface is clean. After cleaning and rinsing the roof, ensure no dirt or
debris is present. Allow surfaces to thoroughly dry to prevent blistering.
DRY TIME:
Drying time depends on weather conditions such as temperature, humidity and air movement.
For specific Safety and Health information please refer to Material Safety Data Sheet.