User's Manual

14
Post-Installation Adjustment
I
1X
J
1X
Once your display is mounted on the wall bracket, you can fine-tune the horizontal level, tilt, pivot, and depth from the wall.
Horizontal Level
Loosen the two screws, as shown, with the included box-end wrench
and adjust the horizontal level +3° to -3°. Use the bubble level to
make sure your display is level, then tighten the screws until secure.
Tilt Angle
Adjust the top and bottom tension screws to the desired friction and
tilt the display up or down +10° to -15°.
+10°
-15°
+3°
-3°