Installation Instructions

9600-0344. Installation and User Instructions for S831 Readers,
Issue 1.0x1 17th Oct. 2003. AMAG Technology, 2003.
Texas Instruments is a trademark of
Texas Instruments Incorporated. Philips and MIFARE are registered
trademarks of Philips Electronics, NV.
FCC Notice: This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may
cause undesired operation.
Any unauthorized modification to this device may void the authority
of the user to operate it.
All trademarks acknowledged.
©
4
Using the Reader
2
Reader Connections
0V
Connect shield at
controller end only
connect to case)
Tx-
Tx+
Rx-
Rx+
12V
Controller connections
(20mA reader port)
Red
Black
White
Blue
Green
Orange
Note: the brown
wire is not used
Reader
Present the proximity card face-on to the reader until you hear a "bleep". If the green indicator is lit,
the card has been accepted and the door is unlocked. If the red indicator is lit, either the card has
not been accepted, or you do not have access through the door. If the red and green indicators
flash alternatively, please wait.
cards can be presented in rapid succession - there is no need to wait for the green or red
LED to extinguish before presenting another card.
Note:
Specifications
Input voltage: 9-14V.
Input current: xxmA @ nominal 12Vdc supply.
Operating temperature: -13 to 158 F (-25 to 70 C).
Operating humidity: 15 to 90%, non-condensing.
Maximum read range: xx" (xxmm).
Approvals: EN50133, R&TTE, IP656.
°°
20mA Current Loop Reader Connections
The reader supports the first two different card types/formats presented after power-up. For
example, unencoded MIFARE and encoded TI cards (in this example, unencoded TI cards would
not be recognized). The reader enters this configuration mode whenever power is re-applied.
3
Reader Configuration