User's Manual

9600-0395. Installation and User Instructions for S822
Encoders, Issue 1.0 28th April 2004. Group 4 Technology,
2004.
HID is a registered trademark
of HID Corporation. i is a trademark of HID
Corporation.
FCC Notice: This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
Any unauthorized modification to this device may void the
authority of the user to operate it.
All trademarks acknowledged.
CLASS
©
Specifications
Input voltage: 9-15V.
Input current: 260mA @ nominal 12Vdc supply.
Operating temperature: -13 to 158 F (-25 to 70 C).
Operating humidity: 15 to 90%, non-condensing.
Maximum encoding range: 1" (25mm).
Approvals: EN50133, R&TTE, IP656.
For internal use only.
°°
2
Encoding Procedure
To encode a card:
1. Log in to the SMS software at the PC that the encoder is connected to.
2. Start the encoding procedure from the appropriate screen in the SMS software. For example, if
you are using a standard client, use the button in .
3.
Encode the Card Holders screen
When prompted, present the card to the encoder. You will hear a "bleep" when the card has
been encoded.
- Lit when power is supplied to the encoder.
- Lit when the encoder has received data.
Beeps once when the card has been encoded successfully.
LEDs:
Sounder:
Red
Green