User Manual

ELECTRICAL SPECIFICATIONS
:
Frequency Range : See Table 1
Pass band Gain @ min attenuation : 60 dB minimum
Manual Gain Control Range : 15 dB minimum
(continuous)
Pass band Ripple : ±1.5 dB (typ)
Noise Figure @+25°C at max gain : 5.0 dB max
3rd Order Intercept point
Uplink : +45 dBm (typ)
Downlink : +45 dBm (typ)
*Output Power @ 1dB Compression
Uplink : +32 dBm (typ)
Downlink : +32 dBm (typ)
*ALC Factory Set Point
Uplink : +25 dBm
Downlink : +25 dBm
Isolation between Up/Down Link : 80 dB min
Input/ Output Impedance : 50 Ohms
VSWR (Input/Output) : 1.5: 1 max
Power Supply : 110VAC/0.80Amp
: 240VAC/0.40 Amp
: 50 to 60 Hz
*The Manufacturer's rated output power of this equipment is for single carrier operation. For situations
when multiple carrier signals are present, the rating would have to be reduced by 3.5 dB, especially
where the output signal is re-radiated and can cause interference to adjacent band users. This power
reduction is to be by means of input power or gain reduction and not by an attenuator at the output of
the device.
Page 5