User's Manual

PWG-600 User Guide
- 53 -
Setting GPRS parameters
GPRS (General Packet Radio Service) is a network service that allows your
handset to be used for sending and receiving data over an Internet protocol (IP)
based network. You can set parameters for using GPRS as follows.
1. From the desktop, press the “Menu” key and select “Settings”. Press the
“Select” key to select “Settings” menu.
2. Select “GPRS” and press the “Select” key. The following submenus are
displayed when you selected the “GPRS” menu.
a. Access Point Name: Select this option and press the “Select” key
to set the name of the GPRS access point.
b. IP Address: Select this option and press the “Select” key to set the
IP address of the GPRS access point.
Pairing a Bluetooth headset with PWG-600
The Bluetooth PIN is used to authenticate two Bluetooth devices (that have not
previously exchanged link keys) with each other and create a trusted relationship
between them. If entered by the user, it is referred to as the ‘Bluetooth Passkey’.
This process of authenticating two Bluetooth devices is called pairing.
A paired Bluetooth headset can be used while making outgoing calls. Once the
headset has been paired, voice is enabled on the headset only for outgoing calls.
During an incoming call, a ring is heard on the paired Bluetooth headset. Press
the button on the Bluetooth headset to accept the call. Press the same button to
terminate the call.
The procedure to pair a Bluetooth headset with PWG-600 is as follows:
1. Put the headset in pairing mode. For example, press and hold the key of
the Bluetooth headset. An intermittent display of the LED takes place.
2. From the desktop, press the “Menu” key and using the navigational keys,
select “Settings” menu and then select “Bluetooth Settings”.
3. Select “Headset” and press the Select” key. The following submenus are
displayed.
a. Find Headset
b. Paired Headset
4. Select “Find Headset” and press the “Select” key. PWG-600 searches for
the available headsets within the Bluetooth range and displays a list of
their Bluetooth names.
5. Select the Bluetooth name of the headset you want to pair with PWG-600,
and press the “Select” key. A screen titled “PIN entry” appears on the
PWG-600 screen.
6. Enter the corresponding PIN (for example, type “0000” if the PIN is
specified as “0000”) and press the “Select” key.
7. Select “Paired headset” and press the “Select” key. The paired headset is
shown in the list of paired devices.