User's Manual

PWG-600 User Guide
- 21 -
• Select “General Configuration” and press “Select” key.
• Select “Powersaving” using the “Down” key and press the “Select” key.
The following options are then displayed.
o Enable/Disable
Select “Enable” and press the “Select” key to activate power saving
mode. Selecting “Disable” disables the power saving mode.
Note: For maximum power consumption, please turn off WiFi if not
needed.
• Select “LCD Backlight” using the “Down” key and press the “Select” key.
The following options are then displayed.
o “On”: Select this option to turn on the LCD backlight when the unit
goes to power saving mode.
o “Off”: Select this option to turn off the LCD backlight when the unit
goes to power saving mode.
o Select “Brightness” to adjust the LCD backlight brightness using the
“Down” key and press the “Select” key. There are 3 levels of
brightness, level one being the dimmest while level 3 the brightest.
Select the required LCD backlight brightness required and press
the “Select” key.
Note: For maximum power consumption, please turn off WiFi if not needed.
Making Balance Enquiry
Enter *212# and press the “Accept” key to find out the balance talk time. This is
the talk time that is remaining in your GSM account.
Note: This feature is operator dependent and the numbers may differ from the
above example. Please consult your GSM operator manual on how to make
balance enquiry via SMS.
Connecting a wired headset
Connect a wired headset to the WHS (Wired Headset) terminal on the PWG-600
handset. This is shown on page Error! Bookmark not defined.. You can answer
an incoming call from a WHS if no Bluetooth enabled headset is paired with
PWG-600.
Setting speaker phone volume
You can set the volume of the speaker to a desired level.
To set the volume of the speaker:
• From the desktop, press the “Menu” key.
• Select “Settings” using the “Down key” and press the “Select” key.
• Select “VoIP Settings” and press the “Select” key.
• Select “General” and press the “Select” key.
• Select “Speaker Volume” using the “Down key” and press the “Select” key.
Ten volume levels are displayed ranging from Level 1 to Level 10.
• Select a volume level and press the “Select” key.