User's Manual

PWG-600 User Guide
- 48 -
enter and shall match the ID on the designated
access point that you want to connect to on the
WiFi network.
o Auth. Protocol
 Off
 SIM1 based
 SIM2 based
 EAP-MD5
 EAP-MSCHAPv2
• Encryption: Select “Encryption” and press the
“Select” key to configure the following parameters.
o Protocol: Select any of the following options
and press the “Select” key.
 Disable
 64 bit Open
 128 bit Open
 64 bit WEP
 128 bit WEP
o WEP Key: Select this option, key in the WEP
encryption key and press the “Select” key.
 Key #1 ~ Key #4
Note: Please consult your network administrator for more
information on setting up the network security of your PWG-600
device.
• Advanced: Select “Advanced” and press the “Select”
key to configure the following parameters.
o Power Saving:
 On: Turning this option to “On” enables
power saving mode and prolongs the
battery consumption during WiFi
operation.
 Off: Turns off power saving mode during
WiFi operation.
Note: Setting the power saving to “On” will
enable power saving mode only if the access
point supports power saving mode.
o RTS/CTS Threshold: Select this option and
key in the RTS/CTS threshold setting and
press the “Select” key.
o Frag Threshold: Select this option and key in
the frag threshold setting and press the
“Select” key.