User's Manual

1. Main Menu: The “three-dot” main menu allows you to:
a. Share User ID: A new User requesting access to a drive can 1) send their
phone’s User ID to a Manager with the drive in a  location, or 2) display
their phone’s User ID QR Code to be scanned by a Manager in the same
location.
b. Scan User ID: A drive Manager can scan another phone’s User ID to add them
into their User List. This is a good way to gather User IDs from your team to
give them access to a drive.
c. Share ArmorLock App: Share the ArmorLock app with other Users. This is
especially
 when you are authorizing remote users before you ship
them a drive.
d. Select Add Drive or Remove Drives.
e. View Introduction.
f. Open About screen.
2. Toggle icon: The toggle icon lets you switch between Card view and List view
modes (Show screen shots of cards and
 drives in the list).
3. Drive Card: Once you’ve added a drive your screen shows the “Drive Card” for that
drive. Swipe
 to add a new drive, and when you have  drives added, you
can swipe  or right to toggle between drives.
4. Drive Card Gear Icon: The gear icon is  to each drive and allows you update
and manage drive 
Add a New Drive with the Mobile App
This section takes you through the steps to add a new drive for the
 time. You can
also use these steps to add additional drives to manage with your ArmorLock app.
Setup and Use the Drive
1. Turn on your computer and log-in.
2. Connect the drive to your computer.
a. Note: Connecting the ArmorLock drive to a USB hub is not recommended. If
such a connection is used, a powered USB hub is recommended in order to
supply the appropriate power to the drive.
3. The ArmorLock drive will power on and the LED light under the Lock Symbol will
turn on.
4. Open the ArmorLock app and add a new drive.
a. Card View
 view) – select the Add Drive icon.
b. List View – select the + Add Drive 
5. A "Bluetooth Required" permission will popup, select Allow. Select OK to proceed.
a. Note: ArmorLock uses Bluetooth to connect to drives and must be enabled.
6. If Bluetooth is
 a popup will tell you to turn Bluetooth on.
a. Go to your phone's  and turn on Bluetooth.
b. Reopen ArmorLock and select Add Drive.
7. A "Camera Access Required" permission will popup, select Allow. Select OK to
proceed.
a. Note: Camera access must be allowed to scan QR codes with your phone.
8. Locate the QR code on the back of the drive and scan it with your phone. Three
options will appear:
Getting Started
ArmorLock Encrypted NVMe SSD
User Manual
6