User's Manual

SETUP
Installing the Batteries for the keypad and mouse
z Remove the battery cover
z Insert the supplied Maxell batteries, making sure that the positive (+) and negative (-)
ends of each battery match the polarity indicators inside the battery housing.
z Turn on the keypad and mouse by sliding the Power switch on the underside of the keypad
and mouse .
Connecting
z Plug the USB receiver into an available USB port on your computer.
z Follow any on-screen instructions to complete the default driver installation.
z LED light of the receiver turns on .
z You are now ready to set the identification code to establish a communication link
with the receiver and mouse .
Setting the Identification Code
After your computer detects the USB receiver and the driver software is installed, you must set the
ID code among the receiver,mouse and keypad before you can use it.
z Press and release the setup key on the receiver. The LED is lit.
z Press the connect key on the keypad.
z Once the LED on the receiver turns off, keypad and receiver is set up.
z Press and release the setup key again on the receiver
z Press the connect key on the mouse
z Once the LED on the receiver turns off, the mouse is set up .
z You are now ready to use the keypad and mini mouse set .