User's Manual

KPR04 (Wireless Keypad)

R0415 (Wireless Keypad and Wireless Mouse receiver)

USER MANUAL

Introduction

System Requirements

Hardware

Operating System

Setup

Installing the Batteries

Connecting the Receiver

Setting the Identification Code

Instruction

MULTI MEDIA BUTTON instruction

Content

INTRODUCTION

Introduction

Congratulations on your purchase of this wireless keypad and mini mouse set. This set offers the

latest technology for interference-free operation with 27MHz wireless connection -- 4,096 IDs for

keypad and 2048 IDs for mouse . The keypad and mini mouse set features on/off switch and auto

power saving management for effective power conservation.

This user’s guide describes how to connect the receiver to your computer, install

default software drivers and set up the radio link.

System Requirements

To use the keypad and mini mouse set, your computer must meet the following hardware

requirements

and run one of the operating systems listed below:

Hardware

z PC with an Intel Pentium processor or equivalent

z USB 1.1 interface

Operating System

z Windows 98/WinNT /Windows me /WinXP /Windows 2000

(Driver required in Win98 /WinNT)

PAGE 1
KPR04 (Wireless Keypad) & R0415 (Wireless Keypad and Wireless Mouse receiver) USER MANUAL Introduction System Requirements Hardware Operating System Setup Installing the Batteries Connecting the Receiver Setting the Identification Code Instruction MULTI MEDIA BUTTON instruction Content INTRODUCTION Introduction Congratulations on your purchase of this wireless keypad and mini mouse set.
PAGE 2
SETUP Installing the Batteries for the keypad and mouse z Remove the battery cover z z Insert the supplied Maxell batteries, making sure that the positive (+) and negative (-) ends of each battery match the polarity indicators inside the battery housing. Turn on the keypad and mouse by sliding the Power switch on the underside of the keypad and mouse . Connecting z Plug the USB receiver into an available USB port on your computer.
PAGE 3
NOTE: Make sure that your computer is turned on and has detected the USB receiver before you set the ID code.
PAGE 4
Power management To extend the life of your batteries , power off the battery with the on/off switch located on the back of the keypad while traveling or when you’re not using it . Troubleshooting What do I do if the keypad doesn’t work? --Make sure that the polarity of the batteries is correct. The positive and negative ends of each battery must match the positive and negative connections in the battery housing. --Check that the receiver’s USB connector is firmly attached to the USB port on your computer.