User's Manual

WARNING: The mains plug/appliance coupler is used as a cutoff device, the cut-off device should remain readily
operable.
WARNING: DO NOT INGEST BATTERY, CHEMICAL BURN HAZARD
The remote control supplied with this product contains a coin/button cell battery. If the coin/button cell battery is
swallowed, it can cause severe internal burns in just 2 hours and can lead to death.
Keep new and used batteries away from children. If the battery compartment does not close securely, stop using
the product and keep it away from children.
If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical
attention.
Protective earthing terminal. The apparatus should be connected to a mains socket outlet with a
protective earthing connection.
Batteries in the remote control: Keep the remote control battery away from children. It may cause a fire or chemical
burn if mishandled. Do not recharge, disassemble, heat above 212ºF (100ºC), Replace only with a battery of the
correct type and model number (CR2025 lithium coin cell battery, 3 V).
Ventilation: Do not block any ventilation openings on the back of the device. Put the system in a position and location
that will not interfere with ventilation, to ensure reliable operation of the device and to protect it from overheating. For
example, do not place the device very close to a wall or in front of a curtain that may reduce the heat sink efficiency.
Cleaning: Please note we have included a cleaning cloth with your device. To avoid making scratches to the surface,
we recommend that you use the cleaning cloth included. Before cleaning, please unplug the device from the AC power
outlet.
Sitting or leaning on device: Do not lean against the device and do not sit on it under any circumstances.
Avoid hearing damage: Playing very loud music for an extended period of time can result in permanent hearing loss.
Label location: The product labels and safety related markings are located on the rear panel.
Outside Antenna: If an outside antenna or cable system is connected to this product, be sure the antenna or cable
system is grounded so as to provide some protection against voltage surges and built-up static charges. Article 810 of
the National Electric Code, ANSI/NFP No. 70 information, Section 54 of the Canadian Electrical Code, with regard to
proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size
of grounding conductors, location of antenna/discharge unit, connection to grounding electrodes, and requirements for
the grounding electrode.
Note to CATV system installer: This reminder is provided to call the CATV system installer’s attention to Article 820-
40 of the NEC (of USA) that provides guidelines for proper grounding. In particular, it specifies that the cable ground
shall be connected to the grounding system of the building, as close to the point of cable entry as is practical.
Operating temperatures: The recommended operating temperature range for the Geneva Sound System is 41 to 104
degrees Fahrenheit (5 to 40 degrees Celsius).
CONFORMITY
FCC Regulations
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment
under FCC rules.
FCC ID: ZXX-MODELLBT, ZXX-MODELXLBT
ZXX: Grantee Code, assigned by the FCC.
Canada
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including