User's Manual

TROUBLESHOOTING
GENERAL
How do I clean the speaker cabinet?
The cabinet can be cleaned with a water soaked cloth. Use only a microfiber cloth. Do not use
household paper, because it can contain glass fiber which can leave scratches.
Light soap water can be used, but never hot water. If water cannot clean the stains, pure alcohol
can be used. When cleaning, be careful around the logo and touch icon (control keys). Do NOT
used alcohol around the logo and the touch icons, because alcohol will remove the them.
Do NOT use any house hold cleaner, polish, wax or any other chemicals as it would damage the
cabinet paint.
Why does the Geneva Cinema turn itself off
The Geneva Cinema has an automatic power on and off function.
How do I change the battery of the remote control?
1. Push the included pin into the small hole.
Alternatively you can use one end of a bent paper clip.
2. Press the pin inside, until the battery compartement moves outside.
3. Replace the battery (3V lithium cell, CR2032). Verify that the battery is inserted with the
correct polarity (+ facing up/down).
Power consumption in standby
0.35 Watt (powered off with the remote control or power key on top of the unit).
TV
TV is connected, but there is no Audio from the Geneva Cinema
Check the TV setup menu, select “External Speakers”.
The Volume of analog TV input is too low / too high
There is an advance procedure to adjust the input gain. See support.genevalab.com.
Why has TotalVolume and Voice enhancement no effect to the audio?
TotalVolume and Voice enhancement work only in TV mode, they are not supported in Line-In or
Bluetooth modes.
Can I disable the automatic power-on functionality?
Yes. Hold MUTE for a few seconds.
Can I disable the automatic source selection of the TV audio inputs?
Yes. Hold TV for a few seconds, then select one of the three TV audio inputs with TV.
Normally there audio from the TV, but when play a DVD cannot hear any audio.
Possibly your TV sends compressed audio (AC3 or DTS) via the digital audio inputs (coax or
optical). The Geneva Cinema does not support these formats. Change the settings in the DVD
player menu of the audio output to “uncompressed/PCM audio”.
BLUETOOTH
Geneva Cinema - Manual Page