User's Manual

1312
ENGLISH
VI WI-FI SETUP FOR THE AEROSPHÈRE BASE
Time required: 5 minutes
Once completed: the AeroSphère Base is connected to your Wi-Fi network. Now you are ready to use listen to FM, DAB+ and Audio CD from the
AeroSphère Base.
OVERVIEW

network. The AeroSphère Base must be in same Wi-Fi network as the AeroSphère
speakers.
WI-FI SETUP METHOD WHEN TO USE THIS METHOD
WPS Your Wi-Fi router has a WPS push button for easy network setup.
AeroSphère Network Setup
webpage*
Advanced
method.
go to the “Feature Guide” on aerosphere.genevalab.com

time.
WAC is not supported on the AeroSphère Base
WI-FI SETUP WITH WPS
What is needed for this setup?
Your Wi-Fi router needs to support WPS. There is no computer or smartphone needed for this setup.
Instructions
1. Turn the AeroSphère Base
on.
2. 
green.
3. Press the white “SETUP” button on the back of the AeroSphère
Base.
4. On the Wi-Fi router press the WPS button. Typically a light on the

button for a few seconds. The AeroSphère speaker and the Wi-Fi
router are now starting to connect to each
other.
5. Wait until the status light changes from fast blinking green to

connected to your Wi-Fi
network.
Troubleshooting
 Repeat the procedure.
 Upgrade the software on your Wi-Fi router.
 Try the “AeroSphère Network Setup webpage” method in the
next chapter.
 Check the Genevalab.com support page.
What is WPS?
WPS ( Wi-Fi protected setup ) is a simple way to connect a new device
to a Wi-Fi network. WPS is a common feature on today’s Wi-Fi wireless
routers or Wi-Fi access points. After pushing the white “SETUP” button
on the AeroSphère Base and the “WPS” button on the Wi-Fi access
point, within about a minute the AeroSphère Base will automatically
connect to the Wi-Fi
network.
WI-FI SETUP WITH THE AEROSPHÈRE NETWORK SETUP WEBPAGE
Follow the detailed description in the “Feature Guide” on aerosphere.genevalab.com
BACKPANEL
STATUS LIGHT
yellow AeroSphére Base is starting up, this takes about 20 seconds
green ( constant )
Successfully connected to the Wi-Fi network and successfully connected to at least one
AeroSphère speaker
green ( slowly blinking ) Successfully connected to the Wi-Fi network
green ( fast blinking ) In the process of connecting to the Wi-Fi network
 Wi-Fi setup in progress ( WPS method )
 Wi-Fi setup in progress ( network setup webpage method )
yellow / green / red ( changing ) Software update in progress
How to eject the CD
You can eject the CD with the following
methods:
 Hold your hand about 10 mm above the CD slot. The CD eject
sensor is located above the CD slot. It detects the hand with a
proximity
sensor.
 Use the
button on the remote control
 Use the eject icon in the AeroSphère app
Power switch
Power On / Off
DC power input
Connect to the AC power adapter connector
Radio antenna connector:
Input for external FM / DAB antenna.
F-Type
connector.
Wi-Fi SETUP:
Press: WPS push button setup method
Hold for 10 seconds: Network webpage setup method
Analog audio input
3.5 mm connector
Status light
Shows current status,
see details below